Archer
Hot Topics Subscriber
So you think you're done posting with backer rod, but the ears aren't quite standing like you want. You might have a solid base, but the tips might flop a little bit. Have no fear, there's an answer. Breathe Right strips!! Yes, Breathe Right strips. The product that's helping the nation with snoring cessation and saving marriages everywhere could be just what you need to perfect your dog's ears. And here's how.
WHAT YOU NEED
Don't forget the cute, unposted Doberman puppy

STEP ONE



STEP THREE
YOU CAN ALSO USE DUOEYELASH GLUE OR TORBOTS IN THE PLACE OF THE NAIL GLUE. IT SEEMS TO WORK BETTER THAN THE NAIL GLUE. IF YOU USE THE DUO OR TORBOTS, SMEAR IT ACROSS THE ENTIRE LENGTH OF THE STRIP TO ENSURE ADHERENCE OF THE STRIP TO THE EAR.

STEP FOUR

STEP FIVE

Congrats! You made it! Will be posting a Breathe Right strip removal post int this thread once I take the pictures.
WHAT YOU NEED
- Breathe Right Strips (I like the EXTRA as they are a bit stronger)
- Artificial nail glue
- Nail Polish Remover
- Isopropyl Alcohol or alcohol pads
- Cotton balls
- Scissors
- Zonas tape
- Permanent marker

Don't forget the cute, unposted Doberman puppy

STEP ONE
- Remove Breathe Right strip from package.
- Put tip of strip to tip of puppy's ear. Draw along edge of ear on to the strip so you are tracing the width of the ear on the strip. Make sense?
- Cut the strip along the lines you drew. This should fit the width of your dog's ear at the tip where you will be placing the strip.


- Recheck size of strip you cut to make sure you don't need to make any adjustments. Recut if necessary.
- Using cotton balls and alcohol, or your alcohol pad, gently clean the inside of the ear flap of any dirt or oil. I clean from tip to base, concentrating on where the strip will be. Allow to dry.
- You can also shave the inner flap of the ear where the BRS will be attached. This seems to make it easier for the strip to adhere to the ear. If you do shave the ear, clean the ear flap with alcohol after you shave.

STEP THREE
- Using your nail glue, apply 1-3 drops across the tip of the strip (where you cut). Do only one strip at a time as the glue dries quickly.
- Then put drops down the middle of the strip. I like at least three drops, if not four.
- Then add a few drops across the tip you didn't cut. This will be the part that sticks closer to the base
YOU CAN ALSO USE DUOEYELASH GLUE OR TORBOTS IN THE PLACE OF THE NAIL GLUE. IT SEEMS TO WORK BETTER THAN THE NAIL GLUE. IF YOU USE THE DUO OR TORBOTS, SMEAR IT ACROSS THE ENTIRE LENGTH OF THE STRIP TO ENSURE ADHERENCE OF THE STRIP TO THE EAR.

STEP FOUR
- Time to glue on the strip! I apply the top tip first. Straighten up the ear by pulling up gently on the tip of the ear, like you do to post. Place strip on tip of ear. Apply slight pressure and hold for a few seconds, still pulling up on the ear.
- Do the same for the center portion.
- Apply the bottom tip to the inside of the ear. Press firmly!

STEP FIVE
- Sit back and admire your work

- If you want extra reinforcement, you can wrap some Zonas tape across the top and bottom of the strip to reinforce it. Be mindful of the ear fold when taping and tape in it's natural direction.

Congrats! You made it! Will be posting a Breathe Right strip removal post int this thread once I take the pictures.
Last edited by a moderator:

