Please help! Newbie to ear posting

pudgtiel

Novitiate
Hi everyone!

This is my first post here, so I apologize if this isn't exactly the place for this but I'm desperate.

I got a doberman puppy a week ago, and two days ago one of the molefoam pads the breeder put in came out. I've tried the tampon method, using skin tac, etc. but she just shakes her head and it comes right off. I have absolutely no idea what to do and I'm concerned that she's going to have gone through the cropping only to have floppy ears... She's 16 weeks old in a couple days.

Any advice is appreciated!! Also- how long do I need to post them?
 
Welcome! You came to the right place. Congratulations on your Doberman pup!

There are a couple videos here that we typically point people to.

I used the tampon method with my previous Dobe. With the Dobe before that (I was totally inexperienced) I just used tape like the vet said. Now, I use the backer rod method. It's the same concept as the tampon method, but it uses backer rod instead. Backer rod is a home repair product that is lightweight foam. Its intended purpose is filling gaps and large cracks before caulking is used. You can pick some up at your hardware store or home improvement store. It comes in a roll and you cut off the length you need.

For your Dobie's ears, you wrap the length (4 or 5 or 6 inches – whatever you need based on your Dobe's ears) of rod in tape and go from there. There is a method of turning the tape around on itself (backtaping) that makes the rods sticky on the outside. This sticks to the inside of the ears.

The key is to get those posts nice and deep into the ears. You will not hurt the innards of the ears, because the dog's ear canal is L-shaped. Insert those posts, twisting back and forth (of course use common sense as to how forceful to be) and at the same time pull up on the ear and tape the post to the ear by wrapping a piece of tape around. Contrary to what is often seen, you only need one piece of tape at the tip and one piece of tape at the base of the ear. You do not need to completely wrap the ears in tape.

This early on, you will probably want a bridge made of tape that runs between the ears. Place it low, at skull-level (not up high toward the tip of the ears).

Many people use adhesive, but I have not, and I've had success.

This should get you started. Ask away!
 
Of course, you can just use the tampons for now instead of running out to the hardware store. Just wrap them nicely in tape and remember the key here: Get them deep into the ear canal and pull up on the ear as you tape the post to the ear. Make sure that whatever the end of your post is like, it is somehow covered with soft material so it will not be abrasive to the ear skin.
 
Welcome and congrats on your pup! Of course we love photos around here so post some up.

Here are a couple methods many of us use which are very similar except one uses back taping to hold it in place and the other uses adhesive.
How to Post Cropped Ears (Video)
Doberman ear posting - improved method

I agree that you can use the tampons for now until you can get other supplies.
 
There's plenty of knowledge here to help you out, I use a version of the "improved method" linked above. I use tape only, no glue. I was very nervous about posting but have now done it enough times to where I'm comfortable. And we just had a major breakthrough at our house, my pup let me put in his new posts today by myself for the first time, no shaking, no trying to get away, he just stood there and let me do it. So stay strong and persevere, it'll come to you and you pup. The best piece of advice I got was make sure you put the post deep in his ear and stretch his ear up as you tape. If you fail to either of those steps the posts will shake out. Good luck!
 
There's plenty of knowledge here to help you out, I use a version of the "improved method" linked above. I use tape only, no glue. I was very nervous about posting but have now done it enough times to where I'm comfortable. And we just had a major breakthrough at our house, my pup let me put in his new posts today by myself for the first time, no shaking, no trying to get away, he just stood there and let me do it. So stay strong and persevere, it'll come to you and you pup. The best piece of advice I got was make sure you put the post deep in his ear and stretch his ear up as you tape. If you fail to either of those steps the posts will shake out. Good luck!

So obviously I'm a few days late... sorry. My pup has been keeping me VERY busy. I'm following this method right now. Is this similar to what you're doing?

Currently she keeps shaking the posts out... I don't know if I'm just not putting them deep enough or what. It's starting to really frustrate me!!
 
That's basically what I do, but with less tape and no bridge.
Here's the exact technique I use, this is posted in this forum, not my video, but it's a great tutorial.

<iframe width="560" height="315" src="
" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe>

If the posts are falling out, they're not deep enough, you really want to push them down as far as you can and at the same time pull up on the ear while you tape it. It took me a while to be comfortable pushing down so far and pulling up on his ears but trust me, it won't hurt him and it's necessary to keep the posts in. And try not to get too frustrated, I, along with most others here have been exactly where you are, and I promise it will get better.
 
Thank you so much for these videos having trouble with ear folding in. The breeder showed me to cut the backer rod out of his ears. I just did this method for the first time he shook one post out, I will push a bit deeper next time.
Cheers
 
Welcome! You came to the right place. Congratulations on your Doberman pup!

There are a couple videos here that we typically point people to.

I used the tampon method with my previous Dobe. With the Dobe before that (I was totally inexperienced) I just used tape like the vet said. Now, I use the backer rod method. It's the same concept as the tampon method, but it uses backer rod instead. Backer rod is a home repair product that is lightweight foam. Its intended purpose is filling gaps and large cracks before caulking is used. You can pick some up at your hardware store or home improvement store. It comes in a roll and you cut off the length you need.

For your Dobie's ears, you wrap the length (4 or 5 or 6 inches – whatever you need based on your Dobe's ears) of rod in tape and go from there. There is a method of turning the tape around on itself (backtaping) that makes the rods sticky on the outside. This sticks to the inside of the ears.

The key is to get those posts nice and deep into the ears. You will not hurt the innards of the ears, because the dog's ear canal is L-shaped. Insert those posts, twisting back and forth (of course use common sense as to how forceful to be) and at the same time pull up on the ear and tape the post to the ear by wrapping a piece of tape around. Contrary to what is often seen, you only need one piece of tape at the tip and one piece of tape at the base of the ear. You do not need to completely wrap the ears in tape.

This early on, you will probably want a bridge made of tape that runs between the ears. Place it low, at skull-level (not up high toward the tip of the ears).

Many people use adhesive, but I have not, and I've had success.

This should get you started. Ask away!

Very detailed, awesome explanation. I’m bringing home a baby boy soon and I’m reading up on ear posting methods/tips. I was wondering why you say to bridge above skull rather than near the top of the ears? What is the difference?
 
We use the hair rollers from the dollar store. The best way we found for keeping the post in the ear was to spray the post with loctight spray adhesive. Back tape post and spray. Now they stay in all week. We use goof off and soak them good to remove. We are on the zip tie method right now and her teeth are almost all gone so it shouldn’t be that much longer. The photo is from last Sunday while they were drying out from a post change.
761D2B66-70A1-4D59-8178-4D7F461DAA9D.webp
 
We use the hair rollers from the dollar store. The best way we found for keeping the post in the ear was to spray the post with loctight spray adhesive. Back tape post and spray. Now they stay in all week. We use goof off and soak them good to remove. We are on the zip tie method right now and her teeth are almost all gone so it shouldn’t be that much longer. The photo is from last Sunday while they were drying out from a post change.
View attachment 90288
Aw, she's so good looking! Glad the ears are saying "Yep! I'm willing to stand!" :)
 

Back
Top