@JanS
Some people aren't too keen on stacking boxes, but they can (and do) come in handy.
These are the dimensions of the stacking box I made. You can make shorter in length, just adjust your measurements.
I'm a hands on kind of person, so I hope this makes sense!
You will need:
2 - 1" x 6" x 6'
wood screws
Anti Slip Traction tape (for steps)
The box:
2 sides - 35"
2 ends- 16"
Screw the end pieces to the end of the side pieces
End caps, slide & bottom brace:
cut 2 - 16" lengths & rip them in 1/2 length wise (makes 4 - 1" x 3" x 16" pieces)
Bottom brace - trimmed to fit flat inside the side boards- (Screw from the sides)
End caps - Screw one of the 1"x3"x16" pieces flat on top of each end (flush with the ends)
Slide - Place flat across the box (flush with the sides) and from underneath mark the slider. That's where you'll attach your feet.
Feet - 2-3" piece of scrap left over. Attach the feet to slide so the feet fit inside the box but NOT snug. These will keep the slide from falling off.
Put the Anti slip tape on the end caps and the slide for good grip. I cut it in 1/2 for along the sides also.



Some people aren't too keen on stacking boxes, but they can (and do) come in handy.
These are the dimensions of the stacking box I made. You can make shorter in length, just adjust your measurements.
I'm a hands on kind of person, so I hope this makes sense!
You will need:
2 - 1" x 6" x 6'
wood screws
Anti Slip Traction tape (for steps)
The box:
2 sides - 35"
2 ends- 16"
Screw the end pieces to the end of the side pieces
End caps, slide & bottom brace:
cut 2 - 16" lengths & rip them in 1/2 length wise (makes 4 - 1" x 3" x 16" pieces)
Bottom brace - trimmed to fit flat inside the side boards- (Screw from the sides)
End caps - Screw one of the 1"x3"x16" pieces flat on top of each end (flush with the ends)
Slide - Place flat across the box (flush with the sides) and from underneath mark the slider. That's where you'll attach your feet.
Feet - 2-3" piece of scrap left over. Attach the feet to slide so the feet fit inside the box but NOT snug. These will keep the slide from falling off.
Put the Anti slip tape on the end caps and the slide for good grip. I cut it in 1/2 for along the sides also.


